Phrozen Beige Flex Resin – It’s Beige. It’s flexible. It works!
Spec’s and Properties:
Volume: 500g
XY Resolution: 0.047 mm
Layer Height / Parameter: 10 sec @ 50 um, Delay 3
Cleaning Part: Use alcohol spray to clean models and dry by air gun or compresses air. Do not immerse printed part into alcohol longer than 30 seconds
Application: Prototyping
Key Performance:
Viscosity: 545 cps (25C)
Density: 1.19 g / cm3
Tensile Stress (Break): 40 MPa
Elongation: 50-60 %
Tensile Modulus: 192 MPa
Hardness: Shore 65D
Heat Deflection Temperature @0.45MPa: 100C
Operation:
- Avoid exposure to sunlight and indoor luminescence
- Return resin from VAT to bottle. Be sure to filter
- Please preserve resin in closed opaque bottle to avoid both air and light exposure
- Do not mix resins together
- Please keep the resin away from children
- Please do not dump resin. Please dispose of responsibly. Cure and add to general waste/plastics
Safety:
- Do not eat or swallow resin. If ingested seek medical advice immediately
- Wear goggles to avoid eye contact with resin. If resin comes in to contact with eyes wash thoroughly and seek medical advice immediately
- Resin may cause slight irritation to skin. Gloves should always be worn when handling resin. If allergic reaction occurs stop using immediately
- Resin has mild odour. We strongly recommend you to use in a well ventilated room or area
- Recommended safety equipment: gloves, mask, goggles
- Store resin in a cool dry place. 15-35 degrees recommended
Reviews
There are no reviews yet.